Leash Point

The leash point can be attached to your board using any PVC boat repair glue or the glue supplied in your repair kit. We don't advise carrying out the repair yourself on the leash point area but if you choose to do so you can follow these gluing instructions to help:

1) Inflate the board to 15 psi (if the area is leaking then you should fully deflate the board)

2) Clean the area to be glued - ideally with some acetone or nail polish remover (it works the same)

3) Apply a layer of glue to both surfaces but don’t push them together yet

4) Wait until the glue has dried (approx. 20mins depending on temperature)

5) Now apply another layer of glue to both surfaces

6) Now push the surfaces together making sure no air is trapped. You really need to push down hard onto the piece you are gluing. Pushing from the centre out to the edge. Ideally you need to push hard enough to squeeze glue out of the edge of the piece you are gluing. At the same time you need to heat the area up with a hairdryer to help the glue activate.

7) Keep applying force to the area to make sure all areas are well stuck down. You will need to work hard on the area for about 5 mins.

8) Ideally place a heavy weight on the area for 8 hrs.

*We advise using protective wear such as gloves and goggles